Restore! for Commercial Tile and Concrete Floors
		A Biodegradable floor care system that features unique DST: Dynamic Surface Tension critical to optimum cleaning formulations. DESCRIPTION: Restore! is a fascinating new versatile dual-action product that is ideal for hard tile floor maintenance in kitchens and concrete areas. Restore! will effectively clean hard tile surfaces without leaving any residue behind. Readily biodegradable surfactant system that delivers low Dynamic Surface Tension critical to optimum cleaning – the lower the DST, the faster the cleaning.
Restore! Power Point Presentation Online.  Restore! Power Point Download
FEATURES:
Low odor blend – suitable for high temperature applications Only cleanser normally required. Waste oils/insoluble’s rapidly break from used solution – allowing for easier oil separation in grease traps. Good aquatic toxicity – allows you to meet standards for “green” cleaners Superior penetration and removal of oily/greasy particulate soils ability to clean area where agitation is restricted. Contains no alkyl/nonyl phenols.
BENEFITS:
Unique proprietary surfactant system eliminates the need for built surfactant systems and provides superior DST characteristics. Helps to eliminate accidents caused by slippery floors, saving potential liability claim costs Improves COF in wet conditions Kills bacteria and deters regrowth Increases the life of tile floors, rejuvenating old and worn tiles Floor appearance is unchanged Can be used both indoors and outdoors NSF approved for use in food production areas
Restore! Application Instructions
Deep Cleans and Aids in the Prevention of Slips and Falls. For Use on Quarry Tile, Ceramic Tile, and Concrete. For general cleaning mix 4 to 6 oz. Per gallon of water depending on degree of soil and grease. HOW TO USE IN KITCHEN AREAS For general purpose degreasing in foodservice applications, dilute product at 4-6 ounces per gallon of water. For general cleaning including floor scrubbing, concentration may be reduced to 2-4 ounces per gallon. For use on vinyl, wood and painted concrete surfaces; product should be used at concentration no greater than 4 ounces per gallon of water. This product is not recommended for use at full strength on bare wood, painter or fabric-covered surfaces. May be used with a mop, a sprayer, a pressure washer or steam cleaner. Apply and allow to stand on the surface for 5-10 minutes. Let the cleaner do the work. Agitate with a deck brush or doodle bug to scrub through any grease build up. Pick up dirty solution or rinse with cold or hot water and squeegee to drain when possible. CAUTION: Causes immediate irritation (redness) to eyes, skin, and mucus membranes. Avoid contact with eyes or skin. Wear suitable protective clothing. Wear suitable gloves. Wear eye/face protection. First Aid Measures: Exposure to eyes, rinse with water for 15 minutes. Wash skin thoroughly with soap and water. If ingested, drink quantities of milk or water. Call a physician. KEEP OUT OF REACH OF CHILDREN – DO NOT TAKE INTERNALLY Label directions and Material Safety Data Sheet (MSDS) precautions must be followed. Manufacturer/Distributor will not be responsible for any injury, loss, or damage, if product is used in any manner not consistent with label directions, or if MSDS precautions are not observed.
			Call, 888--893-4292